QuVIS Acuity User Manual - page 178
Loading a clip for remote control
To complete the remote control setup process, you must “load” a clip or media file for playback.
IMPORTANT! If a clip file is placed under remote control using the Sony protocol only playback operations are
supported. If the Odetics protocol is used, the remote edit controller may be used to record/create new clips but
may not be used to append to existing clips. Only QuVIS Virtual Tapes may be edited (insert and assemble)
remotely using the Sony RS-422 protocol. See section
Edit a Virtual Tape
for more details.
1.
From the Play Browser (1/5) menu page, select the clip (media file) you wish to place under remote control.
Note:Even if you are using the Odetics protocol you need only to select a single file. Once the file or clip has
been loaded, the Odetics controller is presented with a list of available clips in the directory specified by the
Odetics Clips Directory setting.
2.
To “load” the selected clip or media file, press the VTR PLAY button. Playback of the “loaded” media file on the
Acuity may now be controlled using the remote serial controller.
QuVIS Acuity
™
Page 177
QSR Version 3.1