QuVIS Acuity User Manual - page 23
Select Audio Output Settings
1.
Navigate to the Play Audio menu page.
2.
Make the appropriate configuration changes Audio Outputoptions.
a.
To route audio channels to the analog stereo output (for monitoring), set the Analog Left/Right Mix
controls.
The combination of these two controls enables multiple audio channels (analog or digital) to be routed
to the analog channel pairs. Both analog audio channels may be monitored from the front panel using
the headphone stereo output jack.
b.
The volume level for individual channels may be set from the Audio Meterscontrol.
c.
Use the Headphone Vol control to set the volume level for analog headphone output (stereo jack is
located on the front of the QuVIS Acuity).
d.
Use the Master volumecontrol to set the volume level for all audio channels. This control is additive,
meaning that if the volume level for individual channels has been set then the master volume control
will use modify each channel in relation to where it is currently set.
Example: If audio channel 1 is set to +5 and the master volume control is set to 50%, the cumulative
result is that channel 1 will be set to +2.5 or 50% of +5.
e.
Set the Master frame delay(if necessary).
This control is used to compensate for timing errors between video and audio normally caused by
external equipment that use frame buffers while routing or converting video or audio.
QuVIS Acuity
™
Page 22
QSR Version 3.3