SSD 605C Product Manual - page 102

6-36  

Programming Your Application

605C Frequency Inverter

LOCAL CONTROL

This block allows the available modes of

Local and Remote operation to be

customised. It also indicates the selected

mode.

Switching between Local and Remote

modes can only be done using the Operator

Station. Refer to Chapter 5: “The Operator

Station” - The L/R Key.

MMI Menu Map

1 SETUP PARAMETERS

2 FUNCTION BLOCKS

3 SEQ & REF

4 LOCAL CONTROL

SEQ MODES

REF MODES

POWER UP MODE

SEQ DIRECTION

REMOTE SEQ

REMOTE REF

                          LOCAL CONTROL

REMOTE SEQ [297] –TRUE

REMOTE REF [257] –TRUE

LOCAL/REMOTE – [298] SEQ MODES

–

LOCAL/REMOTE – [265] REF MODES

–

REMOTE – [299] POWER UP MODE –

FALSE – [281] SEQ DIRECTION

–

Parameter Descriptions

SEQ MODES

Range: Enumerated - see below

Allows the source of sequencing commands to be selected. Local is the Operator Station,

Remote is an external signal. The modes supported are:

Enumerated Value : Seq Mode

0 : LOCAL/REMOTE

1 : LOCAL ONLY

2 : REMOTE ONLY

REF MODES

Range: Enumerated - see below

Allows the source of the reference signal to be selected. Local is the Operator Station, Remote is

an external signal. The modes supported are:

Enumerated Value : Ref Mode

0 : LOCAL/REMOTE

1 : LOCAL ONLY

2 : REMOTE ONLY

POWER UP MODE

Range: Enumerated - see below

Allows the power-up operating mode of the Inverter to be selected. Local is the Operator

Station, Remote is an external signal, Automatic is the same mode as at power-down. The modes

supported are:

Enumerated Value : Power Up Mode

0 : LOCAL

1 : REMOTE

2 : AUTOMATIC

SEQ DIRECTION

Range: FALSE / TRUE

When TRUE, direction is a Sequencing command.

When FALSE, direction is a Reference command.

REMOTE SEQ

Range: FALSE / TRUE

This parameter indicates the present source of the sequencing commands.

REMOTE REF

Range: FALSE / TRUE

This parameter indicates the present source of the reference signal.