SSD 605C Product Manual - Outine

Routine Maintenance and Repair  

8-1

605C Frequency Inverter

8 

R

OUTINE 

M

AINTENANCE AND 

R

EPAIR

Routine Maintenance

Periodically inspect the Inverter for build-up of dust or obstructions that may affect ventilation

of the unit. Remove this using dry air.

Repair

There are no user-serviceable components.

IMPORTANT:  MAKE NO ATTEMPT TO REPAIR THE UNIT - RETURN IT TO SSD DRIVES.

Saving Your Application Data

Although the Inverter retains saved settings during power-down, it would be wise for you to

keep your Operator Station. If your last SAVE TO OP function was made on this unit before the

fault occurred, then the Operator Station will still hold your application data. You can transfer

this back into the repaired unit, if necessary. You may, depending upon your knowledge of the

fault, attempt the back-up of your application data now, refer to Chapter 5: “The Operator

Station” - Copying an Application.

If the fault clearly lies within the Operator Station, then return it for repair.

Returning the Unit to SSD Drives

Please have the following information available:

•  The model and serial number - see the unit’s rating label

•  Details of the fault

Contact your nearest SSD Drives Service Centre to arrange return of the item.

You will be given a Returned Material Authorisation. Use this as a reference on all paperwork

you return with the faulty item. Pack and despatch the item in the original packing materials; or

at least an anti-static enclosure. Do not allow packaging chips to enter the unit.

Disposal

This product contains materials which are consignable waste under the Special Waste

Regulations 1996 which complies with the EC Hazardous Waste Directive - Directive

91/689/EEC.

We recommend you dispose of the appropriate materials in accordance with the valid

environmental control laws. The following table shows which materials can be recycled and

which have to be disposed of in a special way.

Material

Recycle

Disposal

metal

yes

no

plastics material

yes

no

printed circuit board

no

yes

The printed circuit board should be disposed of in one of two ways:

1.  High temperature incineration (minimum temperature 1200

°C) by an incinerator authorised

under parts A or B of the Environmental Protection Act

2.  Disposal in an engineered land fill site that is licensed to take aluminium electrolytic

capacitors. Do not dispose of in a land fill site set aside for domestic waste.

Packaging

During transport our products are protected by suitable packaging. This is entirely

environmentally compatible and should be taken for central disposal as secondary raw material.