SSD 605C Product Manual - Special Menu Features

5-10  

The Operator Station

605C Frequency Inverter

Special Menu Features

Menu Shortcuts and Special Key Combinations

Quick Link Information

When in Advanced view level, pressing the M key for approximately 3 seconds in any

parameter will display link information about that parameter (a message may be displayed

during this time). The information is displayed in the following format:

325- - - 7 ->[245]

Source tag number

Link number

Destination tag number

Note:  The Inverter must be in Configuration mode before links can be edited. However, holding

the M key down in Parameterisation mode will allow the information to be displayed but

the information disappears when the key is released.

Use the  up (

∆) and down (∇)  keys to change the source tag number. If the source number is

changed from zero, the next available link number will be assigned. Press E twice to clear the

link information and return to the parameter.

All link information is also available through the menu LINKS, menu at level 2.

Quick Save to Memory

Holding down the PROG key for about 2 seconds quickly takes you to the SAVE TO

MEMORY menu in the PARAMETER SAVE menu at level 1.

After saving, press the PROG key to return to the previous display.

Changing the Display Language

Holding down the PROG key at power-up takes you immediately to the DISPLAY

LANGUAGE parameter in the MENUS menu at level 1.

Refer to “Selecting the Display Language”, page 5-12 for information on selecting a language.

The selected view level (when previously powered-down) determines how you will exit the

parameter:

•  Operator: releases you into the OPERATOR menu at level 1

•  Basic:

releases you into the MENUS menu at level 1

•  Advanced: releases you into the MENUS menu at level 1

Quick Drive Copy

With an application stored in the Operator Station (refer

to “Copying an Application”, page 5-14),  holding the

down (

∇)  key at power-up takes you immediately to the

ALL PARAMETERS display in the LOAD FROM OP

menu at level 2.The Advanced view mode is

automatically selected.

Note:  Pressing the up (

∆

) key, as instructed, copies all

parameter settings including motor specific data from the Operator Station to the

Inverter.

The Operator Station will still contain the application data, allowing transfer to successive units.

This information is replaced by any subsequent SAVE TO OP operation.

HEALTH

LOCAL

SEQ

REF

1

1

`UP` FOR ACTION

ALL PARAMETERS