SSD 605C Product Manual - Nstalling The
Installing the Inverter
3-1
605C Frequency Inverter
3
I
NSTALLING THE
I
NVERTER
IMPORTANT: Read Chapter 12: “Certification for the Inverter” before installing this unit.
Mechanical Installation
Model Recognition
Product Code
(Blocks 2 & 3)
Weight
lbs/kg
H
all models
H1
all models
W
all models
W1
all models
D
all models
E
all models
Fixings
all models
0055/400
17.4/7.9
0075/400
20.2/9.2
0110/400
20.5/9.3
348.0
365.0
201.0
150
208.0
335.0
Slot 7mm wide.
0055/500
17.4/7.9
(13.70)
(14.37)
(7.91)
(5.90)
(8.19)
(13.19)
Use M5 or M6
0075/500
20.2/9.2
fixings.
0110/500
20.5/9.3
All dimensions are in millimetres (inches)
Note: Details of a through-panel mounting option for dirty air cooling are available from SSD
Drives.
Mounting the Inverter
The unit must be mounted vertically on a solid, flat, vertical surface. It can be wall-mounted, or
mounted inside a suitable cubicle, depending upon the required level of EMC compliance - refer
to Chapter 11: “Technical Specifications” and Chapter 12: “Certification for the Inverter”.
Minimum Air Clearances
Ventilation
The inverter gives off heat in normal operation and must therefore be mounted to allow the free
flow of air through the ventilation slots and heatsink. Maintain minimum clearances for
ventilation as given in the tables below to ensure adequate cooling of the Inverter, and heat
generated by other adjacent equipment is not transmitted to the Inverter. Be aware that other
If wall-mounted, the unit
must be fitted with the
Top Cover firmly screwed
into position.
W
H
W 1
Heat
Sink
Control
D
E
H1
UL Type Top Cover shown for H1
Figure 3-1 Mechanical Dimensions for 605C