SSD 605C Product Manual - Menu Viewing Levels

The Operator Station  

5-11

605C Frequency Inverter

Changing the Product Code

On rare occasions it may be necessary to change the default settings by changing the Product

Code. The Product Code is

referred to in Chapter 2. You can select a different Language field

(with associated frequency) and power rating for the Inverter; other information is automatically

read from the power board.

A special key combination is required to change the product code. This feature is only available

at power-up as a security measure.

•  Hold down the ∆, E and PROG keys, then power-up the Inverter

 An alert message may be displayed, “ALERT CONFIG MODE”. This is warning you that you

have initialised the Operator Station into the configuration mode and therefore parameters

can be changed.

•  Use the up (∆) and down (∇) keys to select a default setting

•  Hold down the E key to exit

The new settings will be saved automatically, and all defaults will be restored.

Note:  Holding down the 

∆

, E and PROG keys whilst displaying the Welcome screen will also

display the product code, but you will be unable to change the parameter. To go to the

Welcome screen, press the PROG key until you enter the Operator menu system, then

press the E key until the Welcome screen is displayed.

Quick Restore Default

A special key combination restores to the Inverter the current product code default values and

Macro 1 parameter values. This feature is only available at power-up as a security measure.

•  Hold down the up (∆) anddown (∇) and  keys, then power-up the Inverter.

Menu Viewing Levels

For ease of operation, there are three `viewing levels` for the Operator Station. The setting for

the viewing level decides how much of the menu system will be displayed.

The choice of menu for each has been designed around a type of user, hence we have the

Operator, Basic and Advanced viewing levels.

Note:  The contents of the OPERATOR menu remains unchanged for all view levels.

Refer to “The Menu System Map”, page 5-5 to see how the viewing level changes the displayed

menu.

To change the viewing level, go to MENUS menu at level 1. The first parameter in this menu,

VIEW LEVEL, selects the viewing level.

Startup Screen Timeouts

Another action of selecting different viewing levels is to introduce a timeout to the Startup

screen. By default, the Startup screen is the SETPOINT parameter, but you can select any

parameter to be the Startup screen.

Operator viewing level

The Startup screen will be displayed after an extended period without a key press when

viewing the Welcome screen or the VIEW LEVEL parameter in the MENUS menu at

level 1.

Basic viewing level

There is no timeout

Advanced viewing level

There is no timeout