Xerox 721 Message Manual - page 146
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS3050
Stitcher is out of wire
The stitcher has run out of wire.
Action
Replace stitcher wire if you are ACT-trained.
or
Contact your systems specialist or Xerox Customer Service.
OS3190
Close rear door
This message instructs you to close the rear door of the printer
before starting or resuming your job.
Action
None.
OS3400
Printer jam... see printer message.
A paper jam has occurred at the area indicated on the printer
control console display.
The printer control console displays one of the following:
CHECK FOR PAPER IN AREA 6. LIFT SAMPLE TRAY.
CLEAR JAM IN AREA 1. SEE INSTRUCTIONS INSIDE MIDDLE
DOOR.
CLEAR JAM IN AREA 2. SEE INSTRUCTIONS AT AREA 2.
CLEAR JAM IN AREA 3. SEE INSTRUCTIONS AT AREA 3.
CLEAR JAM IN AREA 4. SEE INSTRUCTIONS AT AREA 4.
CLEAR JAM IN AREA 5. SEE INSTRUCTIONS AT AREA 5.
CLEAR JAM IN AREA 5, THEN IN AREA 4. SEE INSTRUCTIONS
AT AREAS 5 AND 4.
CLEAR JAM IN AREA 6. LIFT SAMPLE TRAY.
CLEAR JAM IN AREA 7. SEE INSTRUCTIONS AT AREA 7.
CLEAR JAM IN AREA 8. SEE INSTRUCTIONS AT AREA 8.
CLEAR JAM IN AREA 9. SEE INSTRUCTIONS AT AREA 9.
CLEAR JAM IN AREAS 1 AND 2. SEE INSTRUCTIONS INSIDE
MIDDLE DOOR.
CLEAR JAM IN AREAS 2 AND 3. SEE INSIDE MIDDLE DOOR
AND AREA 3 FOR INSTRUCTIONS.
CLEAR JAM IN PAPER TRAY 1. SEE INSTRUCTIONS ON PAPER
TRAY. PRESS i.
CLEAR JAM IN PAPER TRAY 2. SEE INSTRUCTIONS ON PAPER
TRAY. PRESS i
PAPER PATH FAULT. CHECK FOR PAPER IN AREAS 1, 2, 3, 4,
AND 5
TO PREVENT JAMS, BE SURE LENGTH GUIDE IN TRAY IS
POSITIONED AGAINST PAPER.
Action
Remove jammed sheet(s) from area(s) indicated on the printer
control console display (Refer to the problem solving chapter in
your 4635 LPS Operator Guide.)
OS3700
Suspected page-delivery error. Check output.
The last printed sheet may not have reached the stacker tray.
Action
Check the stacker trays, removing any sheet jammed while
entering the tray.
6-70
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE