Xerox 721 Message Manual - page 98
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1298
Specified paper tray not present
A command was entered that refers to a feeder tray not in the
printer configuration.
Action
Reenter the command, using a feeder tray that your system has.
(Refer to the chapter on feeder trays in your 4635 LPS Operator
Guide.)
OS1300
Number of active forms is nn
The maximum number of forms per print job the system will
attempt to keep in forms memory is (number 0-64). This
message appears at installation when forms memory space is
allocated.
Action
None.
OS1310
Number of active fonts is nn
The maximum number of fonts per print job the system will
attempt to keep in memory is (number 0-128). This message
appears at installation when font memory space is allocated.
Action
None.
OS1320
Number of active graphics is nn
The maximum number of graphics per print job the system will
attempt to keep in GHO memory is (number 16-128). This
message appears at installation when graphics memory space is
allocated.
Action
None.
OS1321
Print darkness level is nn.
After entering the DARKNESS command with a level parameter,
this message tells you that the value you have entered is
accepted. If you enter the DARKNESS command with no
parameters, the message tells you the current level setting.
Action
None.
OS1322
Lead edge screen setting is nn
This message confirms that your EDGE (lead edge screen)
command parameters have been accepted or provides you with
the current settings if you have not entered new parameters.
Action
None.
OS1323
Energy saver timeout is nn minutes
After entering the ENERGY command with a timeout parameter,
this message tells you that the value you have entered is
accepted. If you enter the ENERGY command with no
parameters, the message tells you the number of minutes
currently set.
Action
None.
6-22
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE