Xerox 721 Message Manual - page 81
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS0731
Updating the IOT‘S memory with test profile info
FEX is loading into the printer‘s non-volatile memory the new
finishing parameters profile you have specified.
Action
None.
OS0732
Finishing exerciser is starting requested print job
FEX has created the test job and is starting to run it.
Action
None.
OS0733
Finishing exerciser utility (FEX) starting . . .
The system responds with this message after you have entered
the FEX command.
Action
None.
OS0734
Finishing exerciser utility: working . . .
FEX is in communication with the printer.
Note:
This message may appear numerous times during the FEX
session.
Action
None.
OS0800
NVM update in progress
****DO NOT DISTURB****
The periodic acquisition of information from the printer control
console is in progress.
Action
Do not disturb.
OS0801
NVM update complete
The periodic acquisition of information from the printer control
console has been completed.
Action
None.
OS0830
Attention Light enabled.
The LIGHT ENABLE command is entered and accepted.
Action
None.
OS0831
Attention Light disabled.
The LIGHT DISABLE command is entered and accepted.
Action
None.
OS0840
Entering Lockout Mode
The lockout diagnostic mode is active.
Action
None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
6-5