Xerox 721 Message Manual - page 218
SFS (STATUS FILE SERVICES COMMAND) MESSAGES
SF6050
A - cannot open file. Abort
The command file needed for the user-created form cannot be
accessed due to system disk error. (“A -” indicates SFS is
aborting.)
Action
1. Retry compiling the form. The message should not reappear
if the failure was an intermittent memory error.
2. If the problem continues, contact your systems specialist or
Xerox Customer Service.
SF6051
A - cannot do I/O to file. Abort
A problem exists with user-created form output due to system
disk error. SFS is aborting.
Action
1. Retry compiling the form. The message should not reappear
if the failure was an intermittent memory error.
2. If the problem continues, contact your systems specialist or
Xerox Customer Service.
SF6060
W - value for 'MAX' exceeds limit.
The MAX statement specifies a number greater than 4 for lines in
the header. The system will use the default value of “1.” (“W-”
signifies “warning”—the system will modify the entry and compile
the form.)
Action
If desired, recompile the form, using a value of 1-4 for MAX.
SF6061
W - text truncated.
Input text is too long to fit into the column width specified in
the WIDTH statement. The system will enter only as many
characters as will fit, ignoring the rest, and compile the form.
Action
If desired, recompile the form, reducing the size of the text
entry.
SF6062
W - default value assumed for ‘Length’
No LENGTH statement was entered for the user-created form.
The system will use either WIDTH value or the actual length of
the content of the column, whichever is smaller, and compile the
form.
Action
None.
SF6063
W - length of content truncated.
The column width value specified in the WIDTH statement for
the user-created form is smaller than the actual content of the
column. The system will enter only as many characters as will fit,
ignoring the rest, and compile the form.
Action
None.
12-4
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE