Xerox 721 Message Manual - page 156
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS6196
Copy sensitive form xxxxxx uses graphics.
A form to be used on selected copies and referencing graphics
has been specified. The system cannot print copy-sensitive
forms with graphics.
Action
Recreate the job, specifying a different form that does not
reference graphics or that is not copy-sensitive.
OS6200
Label and File Block count mismatch. Continue or Abort?
The block count on the tape label differs from JDE. Data loss
may have occurred in the file just processed.
Action
1. Press the
acceptable.
or
Enter the ABORT job command to cancel the job.
2. Recode JDE to match the tape label block count. (Refer to
your 4635 LPS Operations Reference chapter on setting LPS
parameters for additional information.)
3. Restart the job.
OS6300
Current report saturates disk. Enter option: “CONTINUE I” -
continue multicopy mode.
The report currently being input exceeds the capacity of the print
file. Select one of the following:
Action
Enter the CONTINUE I command to resume multicopy printing.
Input slows, resuming speed when more disk space is freed.
or
“PRINT 1” - print one copy of current report
Enter the PRINT 1 command. The system prints one copy of the
report.
or
“ENDJOB” - print all copies of report so far, end
Enter the ENDJOB command. All material already in the print file
is printed; the rest is abandoned.
or
“ABORT O”- abort current report
Enter the ABORT O command. The current report is deleted.
or
“ABORT JOB x” - abort current job
Enter the ABORT job command. The entire job is cancelled.
OS6350
Accounting data may be corupt.
An irrecoverable error occurred while the system was updating
the accounting file. Some information may be lost or inaccurate.
NOTE: While no immediate action is required, the accounting
logs should be examined carefully if this message appears.
Action
None.
6-80
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE