Xerox 721 Message Manual - page 197
PDL (JOB SOURCE LIBRARY COMPILATION) MESSAGES
PD8570
Device does not exist %0.
The specified device does not exist. Check command and retry.
Action
None.
PD8800
Insufficient dynamic memory, try rebooting system.
Not enough core memory remains for the entered command.
Compiling will abort.
Action
1. Reboot the system by pressing the Boot button and entering
B at the keyboard.
2. Retry compiling JDL.
3. If the message reappears, contact your systems specialist or
Xerox Customer Service.
PD9400-PD9480
Disk error —xxx file.
The system is unable to access or perform any operation on the
indicated file because of a fatal system disk error.
Action
1. Retry the command. This message should not reappear if the
failure was an intermittent system disk error.
2. If the message reappears, contact your systems specialist or
Xerox Customer Service.
PD9400
DISK ERROR—JDL FILE
PD9410
DISK ERROR—WORK FILE
PD9420
DISK ERROR—SOURCE FILE
PD9430
DISK ERROR—CME FILE
PD9440
DISK ERROR—PDE FILE
PD9450
DISK ERROR—PRINT FILE
PD9460
DISK ERROR—PCC TABLE
PD9470
DISK ERROR—CATALOG FILE
PD9480
DISK ERROR—RTEXT FILE
PD9500
Open error —Print File.
The system is unable to open the print file due to a system disk
error.
Action
1. Retry compiling.
2. If the message reappears, contact your systems specialist or
Xerox Customer Service.
PD9510
PDL restart error opening Save File.
At termination of PDL processing, an attempt to save the file was
unsuccessful due to a system disk error.
Action
1. Recompile JDL and retry.
2. If the problem continues, contact your systems specialist or
Xerox Customer Service.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
7-5