Xerox 721 Message Manual - page 48
IFU (INTERPRESS FONT UTILITY) MESSAGES
IF2233
Incomplete Interpress font read; missing font file(s).
When the Interpress font was written to the medium via the IFU
COPY WRITE command, there were missing font files on the
system. The read will complete successfully, but will not add the
missing font(s) that are mapped to the Interpress font to the
system.
Action
Copy the missing fonts onto the system. Since the missing fonts
are not indicated, use the IFU FIL/EX command on the Interpress
font read to see which fonts were not read in.
IF2234
Output listings of Interpress fonts may be incomplete.
The output file filled during execution of a “wildcarded” IFU LIST
command and some of the Interpress fonts stored on the system
may not be listed.
Action
Retry the operation by entering a number of IFU LIST commands
with specific parameters. This will allow the system to list all
Interpress fonts within each parameter.
IF2235
Please confirm deletion of wildcarded Interpress font
Upon entering the IFU DELETE command, you are asked by the
system to confirm this operation by entering C to continue or A
to abort.
Action
Enter C or A as appropriate.
IF2236
Response was received unsuccessfully!
The operator's response was not received correctly.
Action
None.
IF2237
Package %0 issued unknown message number %1.
This is a general error message.
Action
None.
IF2239
Font x already exists on system, renamed to: y.
During execution of the IFU COPY READ command, the system
is renaming the indicated font before it copies it onto system
disk because a font with the same name already exists on system
disk.
Action
None.
IF2240
Bad line spacing override value was found in font profile.
The line spacing override value is not a numerical value in the
font profile.
Action
1. Make appropriate changes in the font profile.
2. Retry the ADD command.
5-10
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE