Xerox 721 Message Manual - page 87
OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
OS1011
Starting diagnostic print job
The system diagnostic interface (SDI) task is involved.
Action
None.
OS1012
ALUN$ failed command ignored
The device substitution specified in the SUB DEV command has
failed. Check command and retry.
Action
None.
OS1013
Device offline, command ignored
The device substitution specified in the SUB DEV command has
failed. Check command and retry.
Action
None.
OS1014
Output cannot be switched--Selected Tray is full
The SELECT or SEPARATE command was entered while the printer
was printing. Output cannot be switched because the entered
stacker tray is full.
The printer control console displays:
OUTPUT TRAY CANNOT BE SWITCHED--SELECTED TRAY IS
FULL
Action
1. Press the
halt printing.
2. Unload the full stacker tray.
3. Press the
4. Reenter the SELECT or SEPARATE command.
OS1015
ALDN$ failed, command ignored
The device substitution specified in the SUB DEV command has
failed. Check command and retry.
Action
None.
OS1016
NT01 or staple not supported
4635 does not support Staple. If Staple is specified in a JDE, JDL
or DJDE, then INPUT will ignore it.
Action
None.
OS1017
Physical device %0 substituted for logical device %1.
The device substitution specified in the SUB DEV command has
taken place.
Action
None.
OS1020
Job xxxx has completed input phase
All requested manipulation of data is complete and final imaged
pages are in the print file.
Action
None.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
6-11