Xerox 721 Message Manual - 10.
10.
PSC (printer subsystem
controller command) messages
The PSC command enables the selectable download of a printer
controller and RIP software. (Refer to your 4635 LPS Operations
Reference chapter on managing LPS resources for additional
information on the PSC command.)
PS1060
Initializing printer.
The printer is being processed and set at its starting values.
Action
None.
PS1061
Initializing CSI.
The printer controller software (CSI board) is being downloaded.
Action
None.
PS1062
Initializing RIP n.
The RIP board requested is being processed.
...Downloading Software Version xxxx
The RIP software version listed is being downloaded. If the
download is successful, no more messages are displayed. A
download error, however, causes one or more of the following
messages to appear:
....Device not configured in system
The RIP board specified for downloading has not been
configured into the system during the latest sysgen.
Action
Reenter the command line without specifying the RIP board.
or
If authorized to do so, perform a mini-sysgen and configure the
desired RIP board into the system.
or
Contact your systems specialist or Xerox Customer Service.
....Device not installed in system
A RIP board not physically installed in the system has been
specified for downloading.
Note: It is possible for a RIP board to be configured into the
system but not actually installed.
Action
Reenter the command line without specifying the RIP board.
or
Contact your systems specialist or Xerox representative about
having the specified RIP board physically installed into the
system.
XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE
10-1