Cabletron Systems Netlink FRX4000 User Manual - Configuring Subscriber Ids
Atcl
(Autocall) causes a BSC TPAD to automatically call its HPAD when the controller
(identified by Link Address) becomes active. This parameter has no function if the
port is an HPAD.
Rtytm
is the Retry Timer, which determines the time between autocall retries.
Rty#
is the maximum number of times an autocall will be sent.
Conn ID
is an internal connection identifier that will link the BSC port with a device configured
in the
BSC Devices
file (described on page 10-11).
Configuring Subscriber IDs
This operation configures the called and calling addresses that will be used in X.25
call setup if BSCI is being transported over a logical X.25 port. To complete the con-
nection, the software must recognize where the call is coming from (calling address)
and where it is going (called address).
To display a list of current Subscriber IDs (addresses), press
[A]
at the Connections and
Routing Paths Menu
(or
[A], [D], [A]
from the Main Menu).
To add or change a Subscriber ID, press
[B]
at the Connections and Routing Paths
Menu. When prompted, enter a Subscriber ID of up to 15 digits. (ID conventions are
described on
page 8-22
.)
Figure 10-3 Typical SVC Subscriber Screen
[A],[D],[B]
from Main Menu
Node Name=nodexyz
SVC Subscriber Maintenance
*
Subscriber ID
0100012345
A Subscriber Name
sub1
B Routing Algorithm
0, Round Robin
C Systematic Redirection
N
D Redirect on Busy
N
E Redirect on Out of Order
N
F
Connection Priority
0
G Routing Paths
H Redirection Addresses
Option: