Cabletron Systems Netlink FRX4000 User Manual - page 222
13-6
FRX4000/FRX6000 4.0 User Guide, Rev 01
Figure 13-2 IP Interface Record – Frame Relay Example
[A],[C],[E],[B]
from Main Menu
Destination IP Address
is displayed only if
Enable Inverse ARP
is
N
.
Source IP Address
is displayed only if
Unnumbered Interface
is
N
.
Some changes to IP Interfaces and Static Routes (described later) require
an extra step to update the FRX4000/6000 software. Changing certain
parameters will generate the message:
Dynamic Routing Parameters have
changed. ............. Do you wish to update them at this time Y/N (N)?
This must
be done, but if you are making several changes to IP Interfaces and Static
Routes, you can save time by specifying
N
for each change until the final
one. Entering
Y
after the final change will update all changes made to both
IP Interfaces and Static Routes.
If you forget to specify
Y
after the last change, you can still update the node
via
On-line Update Dynamic Routing Parameters
,
[G]
at the
IP/LLC2/BRIDGE/IPX Defaults Configuration menu (or
[A], [A], [E], [G]
from the Main Menu).
If the
Interface Type
is
Ethernet
,
802.3
, or
802.5
, there will be a menu item called
Con-
figure Secondary Addresses
. Selecting this item will display a screen similar to the
following.
Node Name=nodexyz
IP Interface Configuration
*
Interface Number: 10
A Maximum Transmission Unit
4096
B Routing Metric Count
0
C ICMP Redirects
Y
D RIP Support
0 Enabled
E RIP Flash Updates (sec)
60
F
RIP Full Updates (sec)
120
G Priority
5
H Bandwidth Allocation Group
1
I
Interface Type
FRL
J
Source Card
0
K Source Port
0
L Source DLCI
16
M Enable Inverse ARP
N
N
Destination IP Address
100.100.2.1
O Unnumbered Interface
N
P
Source IP Address
100.100.2.2
Q Network Mask
255.0.0.0
Option: