Cabletron Systems Netlink FRX4000 User Manual - page 50
3-12
FRX4000/FRX6000 4.0 User Guide, Rev 01
G
Review Model Information
– displays the maximum number of
logical connections allowed, and lists the protocols installed, on the
FRX4000/6000.
H
Configure Bandwidth Allocation Groups
– (Chapter 7) defines up
to 16 groups that assign connection priorities to various types of
traffic.
B
Configure RLPs
(FRX6000) or
Configure Protocols
(FRX4000)
(Chapter 5)
A
ReviewRLP
(or
Protocol
)
Configuration
– on an FRX6000, identifies
any RLPs (see below) already configured in the node. On any node type,
displays installed protocols and identifies installed Line Interface Cards.
B
Configure RLP
(or
Protocol
) – on an FRX4000, allows specifying the
type of serial expansion card. On an FRX6000, allows specifying the
types of Line Interface Card and protocols installed.
C
Display RLP
(or
Protocol
)
Memory Status
– displays a table showing
available and used memory on each RLP (or in the similar functionality
in the FRX4000).
C
Configure Ports
A
Configure RLP Ports
– (Chapter 6 through Chapter 11) specifies each
serial port's type, physical interface, and operating parameters.
B
Configure LAN Ports
– (Chapter 5) specifies the type (Ethernet or
Token Ring) and associated addresses for each LAN interface on an
FRX4000
or
FRX6000
.
C
X.25 Address Translation Templates
– (Chapter 8) displays, specifies,
and tests templates that are applied to incoming and outgoing call
packets for the purpose of translating selected fields of a packet that may
not otherwise be in a compatible format.
A
Review X.25 Address Translation Templates
B
Configure X.25 Address Translation Templates
C
Test X.25 Address Translation Templates
D
Configure Logical Ports
– (Chapter 8) specifies operating parameters
for logical ports residing on physical frame relay ports.
E
Configure IP/LLC2/BRIDGE/IPX Interfaces
A
Review IP Interfaces
– (Chapter 13) displays information on any
IP interfaces (see below) configured in the FRX4000/6000.
B
Configure IP Interfaces
– (Chapter 13) specifies addressing and
operating parameters for IP interfaces (X.25, frame relay, or LAN).
C
Review
Bridge Ports
/
LLC2 Interfaces
– (Chapter 9, Chapter 15)
displays information on any bridge or LLC2 interfaces (see below)
configured in the FRX4000/6000.
D
Configure
Bridge Ports
/
LLC2 Interfaces
– (Chapter 9,
Chapter 15) specifies location, type, and format of any bridge or
LLC2 interfaces.
E
Review IPX Interfaces
– (Chapter 14) displays information on
any IPX interfaces (see below) configured in the FRX4000/6000.
F
Configure IPX Interfaces
– (Chapter 14) identifies any IPX
interfaces. Identifies type (X.25, Ethernet, etc.) and operating
parameters.
F
Configure BSC Devices
(Chapter 10)
A
Review BSC Device Configuration
– displays information on any
BSC Interactive devices (see below) that are configured.
B
Configure BSC Devices
– identifies devices using FRX4000/6000
ports configured as BSC Interactive.