Cabletron Systems Netlink FRX4000 User Manual - page 51
Introduction to Database Configuration
3-13
G
Review LAN Card Configuration
– (Chapter 5) on an FRX6000,
displays information on any installed LAN cards.
D
Configure Connections and Routing Paths
A
Review Subscriber IDs
– (misc. chapters) displays information on
any subscriber IDs (see below) configured in the FRX4000/6000.
B
Configure Subscriber IDs
– (misc. chapters)
identifies end users of the FRX4000/6000, and specifies parameters for
redirecting traffic to other ports.
C
Review Abbreviated Addresses
– (Chapter 10) displays information
on any abbreviated addresses (see below) that are configured.
D
Configure Abbreviated Addresses
– (Chapter 10) specifies short
versions of subscriber IDs that can be used in place of the full
addresses for async PAD subscribers.
E
PVC Configuration
– (Chapter 7 [
frame relay
], Chapter 8 [
X.25
],
Chapter 12 [
async
]) displays/specifies "permanent" connections
between ports on an FRX4000/6000.
A
Review PVC Configuration
B
Configure PVCs
F
Review IP Routing
– (Chapter 13) displays information on any IP
routes (see below) configured in the FRX4000/6000.
G
Configure IP Routing
– (Chapter 13) defines routes for IP traffic
through the FRX4000/6000.
H
Review IPX Routing
– (Chapter 14) displays information on any IPX
routes (see below) configured in the FRX4000/6000.
I
Configure IPX Routing
– (Chapter 14) defines routes for IPX traffic
through the FRX4000/6000.
E
Configure Frame Relay Backup Groups
– (Chapter 7) allows creation of
one or more frame relay ports/DLCIs that will act as backup(s) for a
port.
A
Review Frame Relay Backup Groups
B
Configure Frame Relay Backup Groups