DAELIM VJF125 Service Manual - page 151
10-13
CYLINDER HEAD / VALVES
Assemble a new gasket to the tensioner lifter, and
install the tensioner lifter on the cylinder.
Tighten the tensioner mounting bolts to the specified
torque.
TORQUE : 1.2 kgf m (12N m)
Install the O-ring and sealing screw to the tensioner
lifer.
Tighten the sealing screw to the specified torque.
TORQUE : 0.4 kgf m (4N m)
Fill clean engine oil into the operating parts of the
cylinder head.
Adjust the valve clearance. (
2-6)
Install the crankshaft hole cap and timing hole cap.
TORQUE :
CRANK SHAFT HOLE CAP : 0.8kgf
m(8N
m)
A.C.GENERATOR CAP :
0.6kgf
m(6N
m)
Remove oil from the cylinder head cover grooves, and
accurately assemble the gasket to the cylinder head
cover.
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
ORIGINAL NUMBER
Install the cylinder head cover.
Tighten the cylinder head cover bolts to the specified
torque.
TORQUE : 1.0 kgf
m(10N
m)
Be sure to check to see if the original number(stamped)
is accordance when replace the cylinder head and
camshaft hold.
Be sure to replace as a set with accordance number for
example, A054