DAELIM VJF125 Service Manual - page 223
16-4
HYDRAULIC BRAKE
Connect a bleeder hose to the caliper bleeder valve.
Loosen the bleeder valve and pump the brake lever or
pedal.
Stop pumping the lever or pedal when no more fluid
flows out of the bleeder valve.
BRAKE FLUID FILLING
Fill the reservoir with DOT3 or DOT4 brake fluid up
to the upper level.
Connect a recommended brake bleeder to the bleeder
valve.
Pump the brake bleeder and loosen the bleeder valve,
adding fluid when the fluid level in the master cylinder
reservoir is low.
Repeat the previous step procedures until air bubbles
do not appear in the plastic hose.
Tighten the bleeder valve.
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
BLEEDER HOSE
Do not mix different types of fluid. There are not
compatible.
If a brake bleeder is not available, fill the master
cylinder and operate the brake lever or pedal to
fill the system.
BLEEDER HOSE