DAELIM VJF125 Service Manual - page 217
15-12
REAR WHEEL/REAR SUSPENSION
INSTALLATION
Apply thin coat of grease to the swingarm pivot bolt
surface.
Install the swingarm into the frame, then install the
pivot bolt from the left side.
Install the U-nut.
Hold the pivot bolt using a special tool, tighten the U-
nut to the specified torque using the same tool.
TORQUE : 8.8 kgf
m
Install the swingarm-to-rear cushion lower flange bolt,
then tighten the bolt to the specified torque.
TORQUE : 4.0 kgf
m
Install the brake hose clamp correctly.
Install the rear caliper bracket into the groove of the
swingarm.
Install the rear wheel mudguard.
Install the rear wheel. (
15-3)
Install the removed parts in the reverse order of
removal.
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
LOWER FLANGE BOLT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT
U-NUT