DAELIM VJF125 Service Manual - page 33
2-9
INSPECTIONS / ADJUSTMENTS
DRIVE CHAIN INSPECTION
Lubricate with #80-90 gear oil after removing the
contamination of chain with a cleaner, and drying
fully.
Because an extremely lubricated oil splash while
the chain moves round, clean it with a piece of
cloth.
After checking a wear and damage of the drive
chain, replace it if necessary.
After inspecting an excessive wear and damage of
the drive sprocket, replace it if necessary.
DRIVE CHAIN INSTALLATION
Install the drive chain.
Install the master link and retainer clip.
Check the attaching bolts and nuts on the drive and
driven sprockets.
If any are loose, tighten them to the specified torque.
TORQUE :
DRIVE SPROCKET BOLT : 1.2kgf
m(12N
m)
DRIVE SPROCKET NUT : 5.9kgf
m(59N
m)
Always replace the chain and sprocket as a set.
Because using the stretched chain and new sprocket
or similar case, the parts will damage quickly cause
by the pictch is not engage each other.
When installing the drive chain, it should be installed
in order that the choked part of the clip can direct to
a progressing derection of the chain.
WIPE AND DRY
GEAR OIL(#80-90)
DAMAGE
WEAR
NORMAL
RETAINER CLIP
MASTER LINK
OUTSIDE
RETAINER CLIP
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET
DRIVE SPROCKET