DAELIM VJF125 Service Manual - page 267
Other manuals for VJF125:
Service Manual
of
295
19-8
ELECTRIC STARTER
Install the cir-clip and washers onto the armature shaft.
Install a new seal ring onto the motor case.
Apply grease to the bushing in the front cover.
Install the lock washer onto the front cover.
Install the front cover, aligning its mark with the motor
case mark.
Install the ground cable and mounting bolts, and
tighten the bolts securely.
Install the clutch wire holder.
Install the starter motor cable, then tighten the terminal
nut securely.
Install the rubber cap securely.
INSTALLATION
Coat a new O-ring with oil and install it into the starter
motor groove.
Install the starter motor into the crankcase.
Install and tighten the motor case bolts securely.