DAELIM VJF125 Service Manual - page 287

21-6

TROUBLESHOOTING

INSPECTION

CAUSE OF TROUBLE

Fuse cut.

Battery weak or totally discharged.

Ignition switch damaged or shorted.

Terminal loose of faulty connection.

Wire harness damaged.

Faulty fuel level sensor connection.

Damper  oil  inside  the  meter

insufficient.

Faulty  connection  between  the

sliding arm and the resistance.

Terminal  connection  loose  or  faulty

connection.

Balance  coil/lead  shorted  or

damaged.

GAUGE NEEDLE SHAKES OR VERTICALLY WOBBLES. (IGNITION SWTICH ON)

1. Operate the turn signal to check the

battery circuit.

2. Remove the tank and operate the

float.

3. Move the float rapidly. One

up/down motion per second.

4. Start the engine, and measure the

fuel level sensor resistance.

5. Check each joint.

Signal continuously

operates dim or does not

operate at all.

Needle not moving.

Needle not moving.

Resistance changed

significantly.

Unsatisfactory

Signal operates satisfactorily.

Satisfactory

Needle moving.

Needle moving.

Resistance not changed.