DAELIM VJF125 Service Manual - Crankshaft Installation
12-8
CRANKCASE/TRANSMISSION/CRANKSHAFT
RH. Crank Case
Remove the main shaft bearing set plate.
Remove the main shaft bearing, counter shaft
bearing and crank shaft bearing form crankcase.
Apply the new bearing with clean engine oil and
install it into crankcase.
Insert closely the cooling jet into crankcase.
- Insert angle: 10
2
TOOLS :
MAIN SHAFT BEARING :
- DRIVER / ATTACHMENT, 42
47mm /
PILOT, 20mm
COUNTER SHAFT BEARING :
- DRIVER / ATTACHMENT, 32
35mm /
PILOT, 15mm
CRANK SHAFT BEARING :
- DRIVER / ATTACHMENT, 62
68mm /
PILOT, 28mm
Coat the socket bolt screw part with oil and install
the main shaft bearing set plate.
TORQUE : 1.2kgf
m (12N
m)
CRANKSHAFT INSTALLATION
Coat a new left crankshaft bearing with clean
engine oil and install new bearings into the right
crankcase.
TOOLS : DRIVER
ATTACHMENT, 72
78mm
PILOT, 35mm
Install the crankshaft into the left crankcase with
the following tools:
TOOLS : THREAD ADAPTER
ASSEMBLY SHAFT
CRANKSHAFT ASSEMBLY COLLAR
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE
BEARING SET PLATE