DAELIM VJF125 Service Manual - page 211

15-6

REAR WHEEL/REAR SUSPENSION

INSTALLATION

Install the side collar.

Place the rear wheel into the swingarm.

Install the drive chain over the driven sprocket.

Install the axle from the left side.

Install the dust seal after applying the grease.

If the damper rubber was removed, install the damper

rubber.

Make the part in protection ring face the outside, and

connect the final driven sprocket.

Install the snap ring into the groove correctly.

If the driven sprocket nut was removed, install the nut

after  aligning  the  flange  part  of  fixing  bolt  with  the

sprocket inside groove and install the nuts.

TORQUE : 5.9 kgf

m (59 N

m)

Install the brake disk with literal mark facing out.

Install and tighten the new bolts to the specified torque.

TORQUE : 4.2 kgf

m (42 N

m)

Be  sure  to  install  the  snap  ring  into  the  groove

correctly.

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

SNAP RING

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT

AXLE SHAFT