DAELIM VJF125 Service Manual - Brake Stop Switch
2-12
INSPECTIONS / ADJUSTMENTS
BRAKE PEDAL HEIGHT ADJUSTMENT
Loosen the lock nut and turn the stopper bolt until
the correct pedal height is obtained.
After adjustment, tighten the lock nut securely.
After adjusting the brake pedal height, inspect the
operation of rear brake light switch and brake pedal,
and adjust them if necessary.
BRAKE STOP SWITCH
Adjust the brake stop switch by turning the adjust
nut, pressing the switch so that the brake light will
come on just before the brake pedal is depressed
and brake engagement begins.
HEADLIGHT AIM
Adjust the headlight beam vertically by turning the
headlight case adjustment bolts.
CLUTCH SYSTEM
Measure the clutch lever free play at the end of the
clutch lever.
FREE PLAY : 10~20mm
Adjust the headlight beam as specified by local
laws and regulations.
An improperly adjusted headlight may blind
oncoming drivers, or it may fail to light the road
for a safe distance.
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
BRAKE STOP SWITCH
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
STOPPER BOLT
The adjustment faulty of height may caused that the
brake runs in state of operation.