DAELIM VJF125 Service Manual - page 266

19-7

ELECTRIC STARTER

Install  the  armature  in  the  motor  case,  while

pushing in the brushes into the brush holder.

When  installing  the  armature  into  the  motor  case,

hold the armature tightly to keep the magnet of the

case from pulling the armature against it.

Install the two washers.

Install a new seal ring onto the motor case.

Apply thin coat of grease to the armature shaft end.

Install  the  rear  cover,  aligning  its  mark  with  the

motor case mark.

Install the brushes into the brush holder.

Install  the  brush  holder  into  the  motor  case,

aligning the holder tab with the motor case groove.

Install the following :

- New O-ring

- Insulators

- Washer

- Washer nut

The coil may be damaged if the magnet pulls the

armature against the case.