DAELIM VJF125 Service Manual - Starter Magnetic Switch

19-9

ELECTRIC STARTER

STARTER MAGNETIC SWITCH

REMOVAL

Remove the seat. (

13-2)

Remove the RH. side cover. (13-2)

Disconnect  the  battery 

wire  cable  from  the  starter

magnetic switch terminal.

Disconnect  the  starter  motor  cable  from  the  starter

magnetic switch terrminal.

Disconnect  the  Yellow/Red  and  Green/Yellow

connector from the wire harness.

Remove  the  starter  magnetic  switch  from  the  bracket

of the frame.

STARTER MAGNETIC SWITCH

VOLTAGE INSPECTION

Connect the starter magnetic switch connector.

Shift the transmission into neutral.

Measure  the  voltage  between  the  Yellow/Red  wire

terminal(+) and ground (-).

If  the  battery  voltage  appears  only  when  the  starter

switch is pushed with the ignition switch to "ON", it is

normal.

GROUND LINE INSPECTION

Disconnect the magnetic switch connector.

Check  for  continuity  between  the  Green/Yellow  wire

terminal and ground.

There should be continuity.

OPERATION INSPECTION

Shift the transmission into neutral.

Turn the ignition switch to "ON", and push the starter

switch button.

The coil is normal if the starter magnetic switch clicks.

If  you  don’t  hear  the  switch  "CLICK",  inspect  the

magnetic switch using the procedure below.