DAELIM VJF125 Service Manual - page 226
16-7
HYDRAULIC BRAKE
Make sure the brake pad spring is in place.
Install the new brake pads.
Install the hanger pin.
Install the brake caliper to the fork so the disk is
positioned between the pads.
Install and tighten the new brake caliper mounting
bolts.
TORQUE : 3.0 kgf
m (30 N
m)
Tighten the hanger pin and pin plug.
TORQUE : 1.8 kgf
m (18 N
m)
REAR BRAKE PAD REPLACEMENT
Remove the rear wheel mudguard. (
13-3)
Remove the rear brake hose clamp.
Check the brake fluid level in the brake master cylinder
reservoir as this operation causes the level to rise.
Push the caliper pistons all the way in by pushing the
caliper body inward to allow installation of new brake
pads.
Remove the dust plugs using the L. wrench.
Loosen the hanger pins.
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
HANGER PINS
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER
BRAKE CALIPER