Raymarine HSB Chartplotter User Manual - Object Information

92

HSB Series Chartplotter

Object Information

You can set Object Information ON or OFF. When set ON, object

information is displayed in normal chartplotter operation when the cursor

is placed over a chart object for two seconds. When set OFF, no

information is displayed.

Waypoint Options

Waypoint controls whether or not the waypoints are shown on the Chart

display, with their appropriate symbols. The active waypoint, and

waypoints in the current route are always shown.

Waypoint Numbers controls whether or not the waypoint numbers are

shown for any waypoints in the current route.

Default Waypoint Symbol lets you select the symbol you want used for

waypoint display.

Vectors

Heading, Tide and Course Over Ground vectors can be displayed as a

line from your vessel. The length of the vector is determined by your

choice of SOG and the time period. An infinite vector extends to the

edge of the chart screen.

Heading Vector indicates your current heading.

COG Vector indicates your course over ground.

Tide Vector indicates the tide angle. Tide information is calculated from

the speed through water, compass and position data.

Datum Selection

You can select either WGS 84 or LOCAL datum. In LOCAL mode, you

are presented with a list of datums; use the trackpad to scroll through the

list, then press ENTER to select the option and close the menu.

When you change datum selection, the system attempts to set any

connected GPS to the new mode, using SeaTalk and NMEA set up

commands. A message shows whether the set up was successful or

not.

Chart

Set Up

Parameters