Raymarine HSB Chartplotter User Manual - page 29

14

HSB Series Chartplotter

2.2  Switching the Display Unit On and Off

This section explains how to switch the chartplotter display on and off.

The following description assumes that there is no radar scanner

connected to the chartplotter.

➤

To turn the chartplotter display on, press and hold the POWER key until

the unit beeps. The keys light up and the following caution is displayed:

CAUTION

Raychart chart displays are based on cartographic data that

C-MAP believes to be accurate. However, you should not rely on

these displays as your primary source of navigation. Rather, your

Raychart should be used only as a backup to official government

charts and traditional methods of navigation.

When you have read and understood the caution, press the CONTINUE

soft key. The chart is displayed.

If this is the first time the chartplotter has been turned on, and no chart

card is installed, the display shows the small-scale world map at 0°/0°,

and the default soft keys. Otherwise, the display shows the selected

chart area and any data that were displayed when the display was last

used.

D4277-1

Until unit beeps

➤

To turn the display off, press and hold the POWER key for three

seconds. A countdown timer is displayed; when it reaches zero a beep

sounds, and the display and the key back-lights go off.

Switching the

Display Unit

On/Off