Raymarine HSB Chartplotter User Manual - page 35

20

HSB Series Chartplotter

2.4  Controlling the Display

You control the chart display using the cursor and control keys. You start

all operations with the default soft keys shown below displayed (this is

referred to as the default screen in the following sections).

GOTO

SCREEN

ROUTE

FIND SHIP

D4160-1

When you have completed an action using the soft keys sub-sets, to

return to the default screen, press ENTER; you may need to press

ENTER several times to back-track through the sub-set hierarchy.

Note: If you have set up your system so that the default soft keys are not

displayed all the time, press any soft key to display the labels.

This section describes how to:

• Select the full-screen mode and turn half-screen windows on/off.

• Move around the chart by panning the display, changing the chart

centre and changing the chart scale. Synchronising the chart and

radar images is also described here.

• Customise the screen presentation options.

The chart controls are summarised in the illustration on the fold-

out page at the end of this section. This illustration shows the

dedicated keys on the front side, the reverse side shows the hierarchical

structure of the ROUTE and GOTO soft keys.

Selecting the Mode of Operation

You use the DISPLAY key to select the full-screen mode. If the data is

available on your system, the following modes (described on page 6)

may be selected:

• Chart screen

• Data log

• Radar screen

The DISPLAY key also accesses the soft keys for the half-screen

window options.

➤

To change the mode:

1. Press the DISPLAY key to show the DISPLAY pop-up, then press

again to cycle through the modes available, as shown in the

following diagram.

Controlling

the Display