Raymarine HSB Chartplotter User Manual - page 58
RANGE
Controls chart scale. Displayed vertical distance is
shown in the Status Bar.
- Press top of key to increase the chart distance.
- Press bottom of key to decrease the chart distance.
- Press and hold to change the scale faster.
Trackpad
Controls cursor position on the screen, and also
the sliders and setup options.
Hold the trackpad down to move the cursor faster.
CLEAR
Cancels operation in progress and returns to the
previous display.
Deletes an object/function under cursor control.
POWER
Press and hold until unit beeps to turn on display.
Press soft keys to toggle half-screen window on/off and to
select lower window, press ENTER to finish.
Use the trackpad to select the alarm, then use the softkeys
to adjust parameters and/or toggle the alarm on/off.
Press ENTER to finish.
Press soft key to display required setup menu, then use
trackpad to select option and soft key to change setting
Press ENTER to close menu, and CLEAR to finish.
Soft keys
Press to select option, or highlight option or slider.
Labels change when you press soft/dedicated key.
Elipses (...) after the text indicate that pressing soft
key leads to further options.
MARKS - MOB
Controls waypoint, and Man OverBoard function.
- Press to display waypoint soft keys.
- Press and hold for 2 seconds to activate or cancel MOB.
GAIN
Not used in Chart mode.
Soft Key Labels:
Change when you press a key.
Default soft key labels are shown.
VRM/EBL
Used to measure range and bearing to/between points.
- Position cursor at start point, and press VRM/EBL key to
display the Ruler data box. Select end point using
trackpad, and press ENTER to fix end position of ruler.
MULTI
Controls display lighting and contrast.
- Press to display sliders.
ALARMS
Used to set up the chartplotter alarms.
- Press to display the Alarms set up menu and soft keys,
the soft keys correspond to the selected alarm.
MENU
Provides access to setup options.
- Press to display soft keys.
ENTER
Confirms selection and (if appropriate) clears current
soft key labels. It either performs the selected task,
accepts changes, or leads to display of more options.
When cursor text is displayed, takes cursor control
of the object.
When arrow-head cursor symbol is displayed, drops
the object under cursor control.
DISPLAY
Controls display mode windows.
- Press for display mode and soft keys display.
- Press again to cycle through display modes, and ENTER.
- Press and hold for 2 seconds for full-screen display.
D4154-1
ROUTE
GOTO
SCREEN
SELECT
WINDOW
WINDOWS
OFF ON
Select a slider using the soft key or trackpad.
Toggle between off/on by pressing the soft key again.
Adjust slider using trackpad, and press ENTER to finish.
LIGHT
CONTRAST
O
F
F
50%
SYSTEM
SET UP!
CHART
SET UP!
TRACK
SET UP
GPS
SET UP
SELECT ARRIVAL
ALARM RADIUS
ALARMS SET UP
OFF TRACK ALARM
ANCHOR ALARM
COUNTDOWN TIMER
ALARM CLOCK
OFF
OFF
00:33:00
OFF
ARRIVAL ALARM
0.01nm
FIND SHIP
Press soft key to place waypoint at cursor or vessel, or
display the waypoint list and associated softkeys.
PLACE WPT
AT CURSOR
PLACE WPT
AT VESSEL
WAYPOINT
LIST