Raymarine HSB Chartplotter User Manual - Setting Alarms And Timers

Chapter 4: Further Chart Operations

75

Setting Alarms and Timers

➤

To set up an alarm or timer:

1. Press the ALARMS key. The Alarms Set Up list is displayed,

showing the current settings.

SELECT ARRIVAL

ALARM RADIUS

ALARMS SET UP

OFF TRACK ALARM

ANCHOR ALARM

COUNTDOWN TIMER

ALARM CLOCK

ON

OFF

00:33:00

OFF

ARRIVAL ALARM

0.01nm

D4265-1

2. Use the trackpad to move the selection bar up or down the list. As

each line is highlighted, the soft key labels are updated to show the

current settings and controls, as shown in the example above.

3. Use the up or down soft keys to change the variable controlling the

alarm. For example, for the arrival alarm you can adjust the radius

from the waypoint at which the arrival alarm will be triggered.

The alarm distances can be set in the range 0.01 to 9.99 nm, in steps

of 0.01nm. The timer is set in minutes and seconds, and the alarm

clock in hours and minutes.

4. If required, press the ALARM soft key to toggle the alarm on or off. If

you turn an alarm off, its value is retained and will be used when you

turn the alarm on again.

Note: You can turn all the alarms and timers on and off, except for

the Arrival Alarm which is always on.

5. Press ENTER to save the changes and clear the list.

Alternatively, to abandon the changes, press CLEAR.

Setting Alarms

& Timers