Raymarine HSB Chartplotter User Manual - Displaying The Chart Data

18

HSB Series Chartplotter

5. Close the card cover so that is clicks shut, to prevent water entering

the display unit.

D4158-1

Displaying the Chart Data

The new chart information will be displayed when you move the cursor

into an area covered by the new chart or, if it is already in the area,

change the range scale.

If a chart repeater is connected, the chart is also displayed on the

repeater display. To see the chart you may need to zoom or pan, to

redraw the chart area to the screen.

The boundary of each chart digitized in the current card is defined by a

box or rectangle. (You can switch off the chart boundaries display if you

wish, as part of the chartplotter set up described in Chapter 5.)

➤

To zoom in:

1. Use the trackpad to move the cursor inside one of the chart boxes,

and press the lower part of the RANGE key.

That area is expanded so that you can see more detail. Note that the

smaller the chart box is on the screen, the greater the amount of

detail that is available when you zoom in.

Unless you have turned on the Plotter Mode (see Section 5.4, Chart

Set Up), you cannot zoom in further than the most detailed chart,

and you cannot zoom out further than the world map.

Displaying

the Chart Data