Raymarine HSB Chartplotter User Manual - 5.1 Introduction

Chapter 5: Setting Up the Chartplotter

81

Chapter 5: Setting Up the Chartplotter

5.1 Introduction

Once you have installed your system and are familiar with its basic

operation, you may wish to set it up to operate according to your

requirements, and display information according to your preferences.

This is achieved using the soft key controls that are displayed when you

press the MENU key.

In most cases, you will only need to use the MENU key options when

you first set up your system. However, you may decide to change the

way you have customised some aspects, such as the screen and help

settings, as you become more familiar with your system.

Once you have set the values, they remain as the default settings until

you reset them; they are retained even when you power off your display

unit.

This chapter covers the following topics:

• Changing the default set up parameters

• System parameter functions and default settings

• Chartplotter-specific parameter functions and default settings

It is advisable to check the functions of the parameters, and decide on

the new settings, before making the changes.

Note: If you have a combined Radar/Chartplotter display, the SYSTEM

SET UP menu from the chart display is the same as that accessed from

the radar display. An additional set up menu is available for the radar

functions when you are in Radar mode. Refer to the 

HSB Series

Pathfinder Radar Handbook

 for details.

Chapter 5

Setting Up the

Chartplotter