Raymarine HSB Chartplotter User Manual - 4.5 Cursor Echo

Chapter 4: Further Chart Operations

77

4.5 Cursor Echo

In a combined radar/chart display, or in a system with a radar display

connected via Seatalk, you can set the display to enable cursor echo.

Cursor echo (accessed from System Set Up, described in Chapter 5)

enables you to display a radar cursor on the chart picture, or a chart

cursor on the radar picture (you cannot display a remote chart cursor in a

chart window).

The following options are provided:

• Local cursor: echoes the cursor position between chart and radar

windows on a combined display.

• Remote Cursor (SeaTalk): displays the cursor from a radar display

connected via SeaTalk.

When the appropriate option is switched on, the display shows its own

cursor, plus the cursor of the other display with appropriate cursor text

(RDR or CHT) to indicate its origin. This means that you could move the

cursor over a target on the radar display, and check the identity of the

target by looking at the radar cursor position on the chart plotter.

4.6 GPS Setup

GPS set up page provides you with information and the status of the

tracked navigation satellites. It also provides soft keys to RESTART your

SeaTalk GPS which instructs the GPS to re-acquire the satellite fix, and

to SET UP a SeaTalk Differential GPS, by manually retuning it to a

different differential beacon.

To select GPS Set Up , press MENU, then press the GPS SETUP... soft

key.

The Navigation Status pop-up window, shown on the following page, is

displayed. This window provides, for each tracked satellite, the satellite

number, its signal strength, azimuth angle and elevation angle from your

vessel.

➤

To reacquire the satellite fix, press RESTART GPS.

The GPS restarts; it can take several minutes for the GPS to acquire the

satellite fixes.

GPS 

SETUP!

RESTART

GPS

Cursor Echo

&

GPS Setup