Canon 7086 Series Service Manual - page 122
of
735
Chapter 2
2-64
1) Remove the one screws [1], and remove the cover from power supply cord mount [2].
F-2-224
2) Attach the AC input connector [1] to power supply cord mount.
F-2-225
3) Fix the ground wire [2] with a screw (w/washer) [1].
F-2-226
4) Mount the relay harness unit [2] to the rear side plate [3] of the paper deck with two screws [1].
5) Put the lock of the tie-wrap on the relay harness into the hole of the rear side plate [4] as shown to fix the relay harness in place.
6) Connect the connectors on both ends of the relay harness unit to the heater connector [5] and the AC power supply connector [6].
[1]
[2]
[1]
[2]
[1]