Canon 7086 Series Service Manual - page 142
Chapter 2
2-84
F-2-274
2.10.2 Turning Off the Host Machine
0011-8636
iR7105 / iR7095 / iR7086
2.10.3 Installation Procedure
0011-2711
iR7105 / iR7095 / iR7086
1. Installation Procedure
2. Installation
1) Remove the main controller box cover [1].
- 10 screws [2]
[1]
Speaker unit (upper)
1 pc.
[2]
Speaker unit (lower)
1 pc.
[3]*
Cable (1300mm)
1 pc.
[4]
Cable (1850mm)
1 pc.
[5]
Cord guide
(4 cord guide to be used)
7 pc.
[6]
Voice Guidance Board
1 pc.
[7]
Voice Guidance Board Face Plate
1 pc.
[8]*
Voice Guidance Board Face Plate
1 pc.
[9]
Binding screw (M3X6)
2 pc.
[10]
Binding screw (M4X6)
1 pc.
[11]
Binding screw (M4X40)
2 pc.
[12]*
Binding screw (M3X16)
1 pc.
[13]*
Binding screw (M4X16)
1 pc.
[14]
Ferrite core
1 pc.
[15]*
Clamp
1 pc.
[16]
Users Guide
1 pc.
[17]
User Manual CD-ROM
1 pc.
*Not to be used for this machine
Turning Off the Main Power
When turning off the main power, be sure to go through the following in
strict sequence to protect the machine's hard disk:
1) Hold down on the power switch on the control panel for 3 sec or more.
2) Operate on the touch panel according to the shut-down sequence
indicated so that the main power switch may be turned off.
3) Turn off the main power switch.
4) Disconnect the power cable (for the power outlet).
Before starting to install the Voice Guidance Kit, check to be sure that the
Expansion Bus-D1 has properly been installed.
[1]
[2]
[3]
[4]
[5]
[6]
[8]
[9]
[10]
[14]
[15]
[11]
[12]
[13]
[7]
[16]
[17]