Canon 7086 Series Service Manual - page 75
Chapter 2
2-17
F-2-46
10) Remove the pre-transfer charging assembly front cover [1].
- screw [2]
F-2-47
11) Disconnect the connector [1], and release the locking lever [2] of the pre-
transfer charging assembly; then, remove the pre-transfer charging as-
sembly [3].
Clean the pre-transfer charging assembly using alcohol.
F-2-48
12) While keeping it unlocked, fit in the primary charging assembly, and
connect the connector.
13) While keeping it unlocked, fit the pre-transfer charging assembly in
place, and connect the connector.
14) Mount the primary charging assembly front cover and the pre-transfer
charging assembly cover.
15) Close the front cover.
2.2.7 Mounting the Charging Assembly
0012-2165
iR7095P
1) Remove the transfer separation charging assembly front cover [1].
- screw [2]
F-2-49
2) Remove the screw [1], then the fixing [2] and disconnect the connector
[3].
F-2-50
3) While holding the front side of the transfer separation charging assembly
[1] and A part, pull it out approx 1 cm, and then detach it in upper left di-
rection.
Clean the transfer separation charging wire using alcohol.
All solvent must be fully dry before fitting the parts back in place.
Check to make sure that the solvent is fully dry.
[1]
[2]
[3]
[2]
[1]
[1]
[2]
[3]
- Check to be sure that the solvent is fully dry.
- Check to be sure that the one-way arm [1] of the pre-transfer charging
assembly is on the eccentric cam [2].
[1]
[2]
[1]
[2]
[1]
[2]
[3]