Canon 7086 Series Service Manual - page 371
Chapter 9
9-15
F-9-37
When shifting the thermistor assembly to the rear, take care not to damage
the fixing roller with the thermistor.
5) Remove the 2 thermistor retaining springs [1], and detach the main ther-
mistor [2].
F-9-38
9.5.6.2 Mounting the Main Thermistor
0010-9400
iR7105 / iR7095 / iR7086
When mounting the main thermistor to the fixing assembly, be sure that the
tie-wrap [1] is as shown.
The tie-wrap serves as a stopper by butting against the claw [2].
Check also to be sure that the main thermistor and the fixing roller are not
away from each other.
F-9-39
9.5.7 Sub Thermistor
9.5.7.1 Removing the Sub Thermistor
0010-9448
iR7105 / iR7095 / iR7086
1) Slide out the fixing assembly.
2) Remove the fixing web and the oil pan.
3) Remove the fixing harness cover.
4) Disconnect the connector [1] and remove the screw [2]; then, detach
the sub thermistor assembly [3].
F-9-40
5) Remove the screw [1], and detach the sub thermistor [2].
F-9-41
9.5.8 Thermal Switch
9.5.8.1 Removing the Thermal Switch Unit
0010-9450
iR7105 / iR7095 / iR7086
1) Remove the fixing assembly.
2) Remove the fixing web; then, remove the 2 screws [1] and the oil pan
[2], and detach the fixing harness cover [3].
F-9-42
3) Remove the faston [1], and remove the 2 screws [2]; then, detach the elec-
trode assembly [3] and the thermal switch holder [4].
F-9-43
4) Remove the 4 screws [1], and detach the thermal switch unit [2].
[2]
[3]
[1]
[1]
[1]
[2]
[1]
[2]
[3]
[2]
[1]
[1]
[2]
[1]
[1]
[3]
[2]
[3]
[2]
[2]
[4]
[1]