Canon 7086 Series Service Manual - page 210
Chapter 5
5-24
When removing the stream reading glass retainer, be sure to take care so that
the leaf spring will not come off.
- When mounting the stream reading glass retainer, be sure to hold down
both sides of the leaf spring [A] with your fingers. (Do not bend the leaf
spring.)
- Be sure to mount the stream reading glass [C] while forcing the stream
reading glass retainer [B] against the glass.
- Check to make sure that the side of the stream reading glass and the leaf
spring [D] of the stream reading glass retainer are in contact. Otherwise,
the possible collection of dust on the stream reading glass will lead to
lines in images.
F-5-59
F-5-60
5.4.2.3 When Replacing Components of the Scanning
System
0011-8731
iR7105 / iR7095
CCD unit, copyboard glass, scanning lamp, standard white plate, inverter
PCB
Execute the following service mode item:
1) COPIER> FUNCTION> CCD> CCD-ADJ (shading correction based on
the standard white plate)
5.4.2.4 When Replacing Components of the Scanning
System
0011-8736
iR7086
CCD unit, copyboard glass, stream reading glass, scanning lamp, inverter
PCB
Execute the following service mode items:
1) COPIER> FUNCTION> CCD> CCD-ADJ (shading correction based on
the standard white plate)
2) COPIER> FUNCTION> CCD> DF-WLVL1 (ADF white level; for copy-
board mode)
3) COPIER> FUNCTION> CCD> DF-WLVL2 (ADF white level; for
stream reading mode)
5.4.3 Standard White Plate
5.4.3.1 Removing the Standard White Plate
0011-8033
iR7105 / iR7095
1) Remove the 2 small covers [1]. (Use a precision screwdriver to release the
claw.)
F-5-61
2) Remove the standard white plate [1].
- 4 screws [2]
F-5-62
5.4.3.2 When Replacing Components of the Scanning
System
0011-8732
iR7105 / iR7095
CCD unit, copyboard glass, scanning lamp, standard white plate, inverter
PCB
Execute the following service mode item:
1) COPIER> FUNCTION> CCD> CCD-ADJ (shading correction based on
[A]
[B]
[C]
[D]
[1]
[1]
[2]
[2]