Canon 7086 Series Service Manual - page 345
Chapter 8
8-45
F-8-113
3) Remove the E-ring [1] of the front and the rear of the roller shaft, and
move the bearings [2] toward the inside; then, detach the guide plate [3].
F-8-114
4) Remove the E-ring [1], and remove the bearing [2] to detach the vertical
path roller [3].
F-8-115
8.11.19.2 Removing the Vertical Path Roller 2
0010-9309
iR7105 / iR7095 / iR7086
1) Slide out the deck (right) and the caste 3/4.
2) Remove the 3 screws [1], and detach the right lower front cover [2].
F-8-116
3) Disconnect the connector [1] and the screw [2]; then, detach the guide
plate [3].
F-8-117
4) Remove the E-ring [1] at the front of the roller shaft, and move the bearing
[2] toward the inside; then, detach the vertical path roller 2 [3].
F-8-118
8.11.20 Fixing Feeding Unit Releasing Lever Sensor
8.11.20.1 Removing the Fixing Feeding Unit Releasing
lever Sensor
0010-9313
iR7105 / iR7095 / iR7086
1) Slide out the fixing feeding unit from the main body.
2) Detach the fixing feeding unit front cover.
3) Release the claw of the fixing feeding unit releasing lever sensor [1].
F-8-119
8.11.21 Feeding Belt
8.11.21.1 Removing the Feeding Belt
0010-9314
iR7105 / iR7095 / iR7086
1) Slide out the fixing feeding unit from the main body.
2) Remove the fixing feeding unit front cover.
3) Disconnect the three connectors [1], and remove the screw [2]; then,
detach the harness guide [3].
[1]
[2]
[3]
[4]
[5]
[3]
[1]
[2]
[1]
[2]
[3]
[1]
[2]
[2]
[1]
[1]
[1]
[3]
[1]
[2]
[1]
[2]
[3]
[1]