Canon 7086 Series Service Manual - page 343
Chapter 8
8-43
F-8-101
8.11.14 Registration Roller
8.11.14.1 Removing the Pre-Registration Roller
0010-9050
iR7105 / iR7095 / iR7086
1) Open the middle right cover, and remove the screw [1]; detach the con-
nector cover [2], and remove the two screws [3]; then, detach the rear fix-
ing plate [4].
F-8-102
2) Remove the screw [5], and detach the front fixing plate [6]; then, detach
the preregistration roller assembly [7].
F-8-103
3) Remove the two springs [8], E-ring [9], and arm support shaft [10] at the
front.
4) Remove the E-ring [11], spacer [12], and bearing [13].
F-8-104
5) Perform steps 3) and 4) for the rear; then, detach the pre-registration roller
assembly.
8.11.15 Registration Clutch
8.11.15.1 Removing the Registration Clutch
0010-9136
iR7105 / iR7095 / iR7086
1) Remove the fixing/feed unit.
2) Shift up the releasing lever.
3) Disconnect the connector [1], and detach the harness of the clutch from
the clutch cover [2].
4) Remove the screw [3], and detach the clutch cover [2] and the bearing
[4].
F-8-105
5) Loosen the 2 adjusting screws [1], and detach the registration clutch [2].
F-8-106
0.4±0.2mm
0.4±0.2mm
[1]
[2]
[2]
[1]
[4]
[3]
[3]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]
[13]
[1]
[3]
[2]
[4]
[1]
[1]
[2]