Canon 7086 Series Service Manual - page 525
Chapter 14
14-25
F-14-69
14.8.18 Fitting the Side Guide Timing Belt of the Manual
Feed Tray Assembly
0010-9358
iR7105 / iR7095 / iR7086
Butt the rack plate [1] of the manual feed tray against section A (open state).
Move the slide volume [2] in the direction of B, and fit the timing belt [3] to
the pulley [4].
F-14-70
14.8.19 Fitting the Drive Belt
0010-9363
iR7105 / iR7095 / iR7086
Fit the drive belt to the pulleys and rollers as follows:
F-14-71
14.8.20 Cleaning the Double-Feed Sensor (transmission)
0012-2953
iR7105 / iR7095 / iR7086
If the surface of the double-feed sensor (transmission) [1] is soiled or shows
a build-up of paper lint, clean it to avoid incorrect operation of the double-
feed detection mechanism.
Keep in mind, however, that the fine print [2] on the sensor surface is a no-
tation used for production control, and is not the result of soiling.
F-14-72
[2]
[1]
[4]
[3]
[1]
[4]
A
B
[2]
Pickup motor
Pickup drive belt
Main drive belt
Main motor
Developing/waste toner drive belt
F
:
[1]
[2]