Canon 7086 Series Service Manual - page 339
Chapter 8
8-39
F-8-73
8.11.8 Manual Feed Pull-Out Roller Unit
8.11.8.1 Removing the Manual Feeder Pull-Off Roller Unit
0011-8149
iR7105 / iR7095 / iR7086
1) Open the manual feeder tray cover.
2) Remove the connector cover [1].
- 1 screw [2]
F-8-74
3) Disconnect the connector [1], and remove the cable clamp fixed to the
plate.
F-8-75
4) Release the lever [1] in upward direction; then, slide out the pull-off roller
unit [2], and remove the 2 screws [3].
F-8-76
5) Remove the pull-off roller unit [1] in the direction of the arrow.
F-8-77
8.11.9 Manual Pickup Roller
8.11.9.1 Removing the Pickup Roller
0010-8992
iR7105 / iR7095 / iR7086
1) Open the manual tray paper guide.
2) Remove the left/right stop rings [1] (two each), shutters [2] (two each),
spacers [3] (two each), and rolls [4] (two each).
F-8-78
If the multifeeder is used during installation or if the multifeeder has not been
used for a long time, pickup can fail. If such happens, detach the protective
sheet from the sponge roller, and dry wipe the sponge roller.
8.11.9.2 Mounting the Pickup Roller
0010-8993
iR7105 / iR7095 / iR7086
Mount the pickup roller by reversing the steps used to remove it with the fol-
lowing in mind:
- The front pickup roller and the rear pickup roller are not interchangeable.
- The front pickup roller is identified by its silver- colored collar.
When mounting the pickup roller [1] to the pickup assembly, be sure that
the round marking [2] on the collar (silver) is toward the machine's front,
[4]
[3]
[1]
[4]
A
B
[2]
[1]
[2]
[1]
[3]
[1]
[2]
[1]
[1] [2]
[3]
[4]
[4]
[3]
[2]
[1]