Canon 7086 Series Service Manual - page 634
Chapter 17
17-46
17.5 FUNCTION (Operation/Inspection Mode)
17.5.1 COPIER
17.5.1.1 COPIER Items
0011-5844
iR7105 / iR7095 / iR7086
Operation for Installation
T-17-32
T-17-33
COPIER > FUNCTION > INSTALL
Sub item
Description
Level
TONER-S
Use it to stir the toner inside the developing assembly at time of installation.
1
- Implement visual check if the developing assembly and the connector of the developing assembly are correctly connected before
TONER-S execution.
- During execution, do not turn the power OFF or open/close each cover/ADF.
Operation method:
1) Select the item, highlight it ( 'Check the Developer' is displayed. Do not check the connection of the developing assembly and the
connector of the developing assembly at that time, but check them in advance at the time of installing the developing assembly).
2) Press the OK key to start the operation. The machine will stop automatically when 600 sec count has been taken.
CARD
Use it to make card reader settings as part of installation work.
1
Procedure
Enter a number between 1 and 2001, and press the OK key. (As many as 1000 cards may be used starting with the one bearing the
number you enter.)
At this time, the machine initializes the card control information (group ID and ID number).
E-RDS
Use it to make E-RDS settings (embedded RDS).
1
At using E-RDS function, set to '1'.
Range
0: disable RDS (off); 1: enable RDS (transmit all counter information)
See the chapter of RDS in service manual for more detail.
RGW-PORT
Use it to set the port number for the server used by E-RDS.
1
range: 1 to 65535
COM-TEST
Use it to check the connection to the server used for E-RDS.
1
1) Select the item to highlight, and press the OK key.
2) Check the result expressed in OK or NG.
COM-LOG
Use it to indicate the details of the result of a test executed on the communication with the server used for E-RDS.
1
Procedure
1) Select the item to highlight, and press an information item.
history particulars: calendar, date, time, error code, error details (128 characters max.)
RGW-ADR
Use it to specify the URL of the server used for E-RDS.
1
Procedure
1) Select the item to highlight, and press an information item.
2) When the URL input screen appears, press the OK key.
(default: htts://a01.ugwdevice.net/ugw/agentif010)
COPIER > FUNCTION > CCD
*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item
Description
Level
CCD-ADJ
Use it to execute CCD auto adjustment.
1
1) Place 10 or more sheets of paper on the copyboard glass. (Make sure the paper is the whitest of all used by the user but is not one
for color printing).
2) Select 'CCD-ADJ' to highlight, and press the OK key.
3) See that auto adjustment takes place (about 15 sec), during which 'ACTIVE' appears in the upper right of the screen.
4) See that the LED (scanning lamp) goes on twice in the course of the adjustment and the screen indicates 'OK!' to end the adjustment.
5) All items under COPIER > ADJUST > CCD will be updated. Print out a service sheet for future reference.